OC32 Release Notes 0.0.0.7_en

OC32 Firmware 0.0.0.7

• Added: Bidirectional communication in OC32 message mode
• Added: Reading back the actual and stored pin-configuration

OC32 Config 0.0.0.7

Release 0.0.0.7 of OC32 Config supports the use of the additional possibilities of the firmware.
The tabs are modified somewhat. The old tabs "Servo" and "PWM" are replaced by tab "OC32 Pin CFG".
Within that tab you'll find a sub-tab. Using Set/Write Pin Configuration, the modus is determined by the activated sub-tab. If the "Clear" tab is active, Set/Write Pin Configuration does a Clear/Erase of the pin-modus.
Get/Read Pin Configuration reads the status from the OC32 and activates the corresponding tab.

Convention:

• Get/Set = temporary (so the active configuration)
• Read/Write = permanent (so the configuration in flash)

Hidden Feature: a double-click on the text "Release ..." at the bottom opens an extra field that shows the OC32 response in HEX.